| Packaging |
High quality lithium Polymer cell (LP031418) with PCM Protection module |
| Nominal Voltage |
3.7V |
| Capacity |
Typical |
60 mAh |
| Minimum |
50 mAh |
| Max. Current |
Charge |
30mA (0.5C) Max, 0.2C-0.3C charge recommended |
| Discharge |
60 mA (1C) |
| Ambient temperature |
Charge |
0 deg C to 45 deg C |
| Discharge |
-20 deg C to 60 deg C |
| Storage |
-20 deg C to 25 deg C |
| Cell internal Impedance (at AC 1KHz) |
≤ 500mΩ |
| Nominal Weight |
|
Approx. 1g |
| Dimensions (maximum) |
|
20.0mm (+/-0.5) L x 14.0mm (+/-0.3) W x 3.0mm (+/-0.2) T See below dimension requirements |
| One Protection Circuit Module |
Overcharge |
>4.28V ±0.07V (reset at 4.08V ±0.07V) |
| Overdischarge |
<2.4V ±0.1V (reset at 3V +/-0.1V) |
| Current Limit |
2-5A |
| Short Circuit |
Protection (320uSec) |
| Approx. Weight (g) |
1.0g |
| Dimensions |
20.0mm (+/-0.5) L x 14.0mm (+/-0.3) W x 3.0mm (+/-0.2) T |
| Thermistor |
|
NA |
| Wiring & Connection |
|
Wire sizes are to be 30AWG (with a diameter of ≤0.80mm), tinned and 25 +/-2mm in length – Red (+) & Black (- or com). Battery pack power wires are to be routed on one side of the cell as shown. |
|
